fascias.com

Floplast Domestic Channel Drainage Garage pack. Quality domestic surface drainage 110mm x 100mm, Anti-slip heel guard grating, designed to withstand 5 tonne vehicle weight, 4 outlets per length for maximum flexibility.

► Driveways and pathways
► Patios and conservatories
► Swimming pools and sports areas
► Gardens and water features
► Retaining walls
► Benefits include:

Easy to assemble, handle and install with no special tools required
Recycled material providing environmental benefits (plastic version)
Built in heel guard and anti slip system (plastic version)
Simple click into place positive connection
Innovative, lightweight and durable design
Concave design for easy water flow
Low maintenance required by the user
Easy access for channel cleaning
5 outlet option for multiple FloDrain channel connections
Quad connector for multiple change of Directions.

3 metre Kit contains

3 No Drainage Channels
1 No Endcap
1 No Outlet
 

Description:
Flodrain Surface Channel

Features:
1m length.
Can connect direct to 110mm drain. 
Moulded knock out bottom outlet.
Universal end cap and outlet combined
Debis trap preventing drain blockage.
Moulded in high grade recycled polypropylene. 

Dimensions:
Length = 1m
Height = 135mm
Width = 100mm internal 150mm External

Description:

Flodrain - End Cap Outlet, for use with Flodrain Surface Channel

Manufacturer:

Floplast 

Description:

Flodrain End Cap, for use with Flodrain Surface Channel

Manufacturer:

Floplast 

Description:

Flodrain Corner, for use with Flodrain Surface Channel

Manufacturer:

Floplast 

Domestic Channel Drainage - Easy To Install With Concrete or Paving
1. Dig trench for FloDrain, allowing for 50mm deep compacted sand base and wide enough for a minimum of 100mm backfill of concrete on each side.
2. Fix a string line to finishing height of grate 2mm below final surface level.
3. Allow a fall of approx. 5mm for every 1m length (1:200).
4. Start installation at lowest point of the run to accommodate any cut lengths which should be installed at the point furthest from the outlet.
5. FloDrain joints and end caps to be sealed with silicone sealant.
6. Use an End Cap at highest point of FloDrain.
7. Connect the lowest end of FloDrain to 110mm PVC-U BS EN1401 drainage pipe using either an end outlet or the preformed channel bottom outlet to allow water to drain away. Contact FloPlast for additional coupling details for other connections e.g. clay pipes etc.
8. FloDrain can be cut to length with a hacksaw. Install with grate fitted.
9. Protect grate with tape before concrete is poured.
10.Finish concrete 2mm above level of grate.
11.Allow 72 hours to cure before vehicle use or removing grates.
12.To remove grate, simply run a screwdriver along the edge of the grate to dislodge.
13.If installing block paving or paving slabs, haunch around channel with concrete to a height which allows the depth of the block or slab to finish 2mm above the level of grate.
All FloDrain Installations must be set in Concrete.
Should additional security be required when installing channel
drainage with the galvanised grate, locking bars D725
( 2per 1 mtr length) are required.