Timber Supported Polycarbonate Fixing Bars

Measure and cut the polycarbonate sheet to length allowing an extension of approximately 50mm to overhang the gutter.

Cut the aluminium base section and uPVC top section to the same length as the polycarbonate sheet. Drill holes to suit a 5mm wood screw in the centre of the aluminium base between the toothed legs.

The holes should be 100mm from each end and at no greater than 500mm intervals.

Screw aluminium bases to rafters using wood screws. Lay polycarbonate sheets on rafters starting at one end.

When all sheets are in position, remove the protective film and fit the uPVC top section by pushing the legs into the slots provided in the aluminium base.

Push firmly home to ensure adequate seal. Fit endcaps to uPVC top capping. Fit end closure to polycarbonate sheet.

Refine Search
Sort By:
Display: List Grid
  • Everbuild 700T Neutral Cure Silicone Clear
    Silicone 700T is a fast, neutral cure, low modulus sealant specially formulated for the PVCu and roofline industry. For perimeter pointing window and door frames, sealing plastic roofline areas and general weathersealing. Now contains a powerful anti-fungal compound. ..
    Silicone 700T is a fast, neutral cure, low modulus sealant s...
    Ex Tax: £1.90 £2.28