Cheltenham Door Canopy

A dual pitch, tile effect canopy with imitation woodgrain detail.

Available in a choice of terracotta or slate grey tile effect finish, with lead look flashing detail. Simulated woodgrain detailed fascia & ceiling in white, brown, light oak completes the effect. Designed for ease and speed of installation. 

Manufactured in strong rigid GRP, this attractive overdoor canopy will enhance any entrance door and requires only an occasional wash with warm soapy water to keep its good looks.

Supplied with comprehensive fitting kit and GRP brackets (BRG7) to match the base colour
Available in either 730 or 880 projection, and with the option of a Fleur-de-Lys or T-Bar.

Important

GRP Products are made to order. Ensure your measurements are correct and that you have chosen the right product for your needs. As they are made to order, GRP products are non-returnable.

Fitting Instructions for Cheltenham
1. Find the centre of the door opening and measure out the position for the support brackets, this can vary as long as they fit under the base ends.
2. Fix the brackets level onto the wall using plugs, screws, and cover caps provided.
3. Position bottom tray onto brackets and centralise with the door opening, screw back against the wall and fix the end of each bracket into the tray.
4. Slide top onto bottom tray flange and fix back to the wall through the lead look upstand at approximately 300mm intervals.
5. Clean off any dust or dirt and seal using suitable silicone sealant.
6. Your installation is now completed.
Your canopy will give years of maintenance-free service and requires only the occasional wash with warm soapy water.
NB Do not use abrasive or solvent cleaners on this product.

Cheltenham Fitting Guide - Click Here